![Nick Tullos](/img/default-banner.jpg)
- 91
- 222 249
Nick Tullos
Приєднався 27 лют 2009
I usually post videos of my current projects from wood working to open source software projects.
Xamarin forms MacOS +XCode create new window and display it. (Bad Audio)
The process is so convoluted that I need to record it for future use because I know I will not remember it. This audio didn't record properly.
Переглядів: 257
Відео
How to start a Briggs and Stratton generator
Переглядів 22 тис.3 роки тому
How to start a Briggs and Stratton generator
2008+ Ford Super Duty Cummins Swapped with a factory display gauge working for $30
Переглядів 1,2 тис.4 роки тому
2008 Ford Super Duty Cummins Swapped with a factory display gauge working for $30
Hacking a 2008 Ford Super Duty with a chevy transmission and a Cummins diesel with the CAN Bus
Переглядів 2754 роки тому
Hacking a 2008 Ford Super Duty with a chevy transmission and a Cummins diesel with the CAN Bus
4BT Diesel conversion with TWO throttles
Переглядів 1,5 тис.6 років тому
how to retain factory cruise control and simplify your 4bt conversion!
Jeep Wrangler RX8 Seats FAIL - part 2
Переглядів 1,4 тис.6 років тому
This video is about trying to fab up rx8 seats to fit in this old jeep.
Isuzu 4BD1T diesel NPR Cold Start - custom jeep swap?
Переглядів 4,6 тис.6 років тому
we might use this engine for the jeep swap
Cheapest jeep wrangler on facebook and craigslist
Переглядів 1,2 тис.6 років тому
This video is about Cheapest jeep wrangler on facebook and craigslist
How to remove Jeep Wrangler Seats
Переглядів 32 тис.6 років тому
This video is about How to remove Jeep Wrangler Seats
searching the junkyard for jeep wrangler seats
Переглядів 15 тис.6 років тому
This video is about searching the junkyard for jeep wrangler seats
1997 Jeep Wrangler TJ - project inspection
Переглядів 1,4 тис.6 років тому
1997 Jeep Wrangler TJ - project inspection
Cummins 4BT lite rebuild - part 4 (end of day one)
Переглядів 6176 років тому
Cummins 4BT lite rebuild - part 4 (end of day one)
cummins 4BT vs isuzu 4BD1T - diesel engines w/ exhaust noise
Переглядів 64 тис.6 років тому
cummins 4BT vs isuzu 4BD1T - diesel engines w/ exhaust noise
4bt / 6bt overboost turbo switch in a cummins chevy 2500
Переглядів 1,1 тис.6 років тому
4bt / 6bt overboost turbo switch in a cummins chevy 2500
Last swarm of the year, September 2017
Переглядів 2706 років тому
Last swarm of the year, September 2017
Small hive beetle recovery process part 2
Переглядів 166 років тому
Small hive beetle recovery process part 2
Trying to save a beehive from small hive beetles
Переглядів 476 років тому
Trying to save a beehive from small hive beetles
I just saw one on my wife’s lilies unusual and I’ve never seen one before in Michigan
How abaut the quiet system 2:51
There’s no way a blowby hose can cause a head gasket to blow out
Saludos algún video de una gran blazer con motor ISUZU estoy interesado en un swap 2.8 JB1 isuzu
So the circuit breaker needs to be switched on before I plug in the cord?
Your superb video was incredibly helpful! I was struggling to start my generator, but thanks to your clear instructions, I got it running smoothly. The only hiccup I encountered was with the fuel line. Nonetheless, I'm immensely grateful for your guidance. Once again thank you very much.
“7 minutes, maybe teeeen”
What kind of gas does it use
Use the accessory drive off the timing cover for your vac power steering pump or what ever you want it's there for reason
Did you figure out why ?
blown headgasket
too much boost is my guess, but that was years ago.
I used escort seat in my Jeep. Super comfy
The 2001 Pontiac Sun fire is a direct fit that bolts right on, no fab work involved at all. The seat belt guide hits the roll bar when reclined tho. You can easily cut the off tho.
$2.19 I miss that
yep, the good ole days
Do you still have the fuel spider?
nope
I've been contemplating a diesel swap on my 99 burb. That gives me ideas
Great video my friend with no fluff, needless introductions or stupid stuff. Thank you so much.
I can not thank you enough for this video. I was able to set up my Briggs and Stratton Elite 5550 today in order to feel more secure before Hurricane Ian makes his visit. I am recently widowed so because of your video I was able to "get ''er done." THANK YOU! Greetings from Clearwater, Flordia. And YES, Jim Cantore is here at Clearwater Beach and it isn't for a vacation.
I'm glad it help!
Same here in Bonita Springs/Naples. Not the 'widow' part. My generator is older, as a result so am I, but I am still trainable and appreciate the refresher. The ON/OFF switch on mine was hidden, and no matter how many pulls you try, it won't start in the OFF position !! Beat NAVY !!
I’ve been finding a couple of black ones in my hives
Worst video
Did you get the boost gauge working?
I like the Isuzu better it's more smoother quieter we'll go well in my 2019 frontier King cab which has a four cylinder this will be perfect in it
what transmission are you going to use?
@@NickTullos what would you recommend I was thinking about using the transmission already in the truck maybe a adapter and the transmission
@@williegohard1368 the main problem with the 4BDs is there isn't much aftermarket support. The factory transmission only goes to 1:1 so you don't have overdrive. Once you get it installed please send me a link.
Cool Job, any code ? [CAN]
Thanks Nick. I just hit a search and your video came up. Hope you are doing well.
Funny enough, I was thinking about those good times we had down on Frenchman street last night at the caddo lake camp. Laissez le bon temps rouler!
Hey Nick, What Trans controller did you use? Also, as long as your seals and gaskets are synthetic and not rubber you should be able to run biodiesel without issue. I know guys who have ran it in their tractors for years
I’m running a GM supermatic aftermarket controller for the 4l80e
@@NickTullos So what has your mpg been? By my calculations 450 miles on 1/2 a tank should be around 26 mpg
@@mikefoster6358 I moved the swap to a F350 SD CC LB DRW so my mpg is lower because I'm in a much larger truck, but its still pretty good.
@@NickTullos What was your mileage in the Chevy? Was it around 26 MPG
head gasket
I have to leave choke in middle not all the way to left
which one is easiest" to get adapters for to swap into ie" a 03 gmc 1600 w/ nv4500? any help you could give m, or and sites, laces too find adapters too swap a 4bdt into a gmt-
I've got a 4bdlt I'm getting ready to put into a military M715. I can tell you with absolute certainty that there are vastly more adaptor options for the Cummins. Adaptors for the Isuzu are almost non existent. There were some people making adaptors in the past but doing my research I haven't found anybody currently making adaptors. There are some 4bd1t engines floating around with SAE #3 flywheel housings, early engines in domestic trucks and most industrial engines had them. If you have a SAE flywheel housing you can find a adaptor to fit pretty much any domestic engine. The vast majority of these engines have a "Japanese" pattern, which pretty much doesn't fit anything except the Japanese transmission that is bolted to it. That being said, some careful measuring and a trip to a machine should should net you a adaptor that will work. I currently have my parts at a machine shop to get an adaptor made to bolt up to a Spicer 3053a transmission. Was quoted a price of $500, which is actually cheaper than adaptors you can buy for say a Cummins.
Wow an automatic isuzu npr with 4bd1 engine
I just want to ad that there is also a 6cyl in the FRR. Much like the 6bt, 200 horses and ??? Torque monsters to do work. The one I have seems legit. It pushes a 26ft box loaded with house furniture like a boss.....!
There pretty quite
Isuzu might be the better engine, but the Cummins is unbeatable soundwise imo
Isuzu Engines are just better 🤷 even the 100hp Mechanically Fuel Injected NA version can give 17-23MPG with 2 Tons of stuff in the bed. with a Turbo it is even more efficient it doesn't go below 20MPG's
I've always said my Isuzu diesel sounds like an angry singer sewing machine.
i love your homemade accessory drive. good job
The Isuzu engine is idling rpm is too high. This old Isuzu engine is bullet proof.
My dad has one that has been sitting for 10 years. It runs just fine on 10 year old fuel lol.
we have a Deep Forest Passenger 4X4 that has a NA 4BD1 Engine Diesel prices went sky high and got to the point where the pumps ran out of them so we had to resort to using a mixture of Filtered Used Cooking Oil, Used Motor Oil and some Gasoline and sometimes just filtered Dirty Leftover Marine Diesel from the docks I mean it runs fine no seizing of the engine, no damage to the fuel injector pump 🤷♂ tough engine this is
I noticed that, but I think the NPR trucks have a "high idle" when cold. That could be why it's idling high.
Same with the old Isuzu 4JB1
I got some out of a 2007 pontiac Grand Prix. Ran into the same problem with the electric seat though! It was an easy solution all you need is to bring a mobile battery jump starter. I unplugged the switch and then scavenged some wires from a nearby car to connect the motor to my battery. Motor moved just fine and now I’ve got power seats!
I wish I could find another deal like this one
I have some black bees out of one of my hives too. Been trying to figure out if it’s genetics mixing or what.
I found the hive the black bees are coming from. It’s a carnolian queen but she’s throwing off three different bee genetics .. one being this black bee. I put some drone foundations in the hive to increase my dark drone population in hopes I can pull some genetics from it
Thanks for your share.
If you don’t mind me asking where are you located? I’m in Southern Ohio.
@@BeylasBees thats correct, the queen might be carnolian, but if she was open mated you then you will not know what her babies could look like. Drones are haploid so they could come out black even if the queen isnt.
@@BeylasBees I'm from West Louisiana right next to Texas
WRANGLER YJ 1 991 YEARS ENGINE 4.0 PCM PROBLEMS NEED NUMBER PART FOR NEW PCM OLD PCM 56026982
Nice to see that your back. keep up the great videos.
Nice genny Mr Hackson. :)
That generator is one of my neighbors who needed a tutorial. I was talking about TF2 with some guys yesterday, but I haven't played in years.
Can Isuzu 6BD1 fit also?
My jeep also has 1 tork and 1 13 on that seat. It come from factory with 2 different screws. IDK why
I like it 👍, keep up the great work
Hoping to find some bucket style seats for my Mazda truck at the junk yard and seeing that scion seat reminded me of when I had one
Nicely done! Good to see your back at it again.
Great video!
Which one more power Isuzu or Cummins
I see you still have your amazing killer beard.
You're clever with machines.
Might be the KDP.